eSun ePA12-CF
eSun ePA12-CF
It is a material developed by eSUN and LUVOCOM based on PA12, added with 15% carbon fiber, greatly enhances the strength, rigidity and toughness of nylon, and can be used as a substitute for metal in many occasions; low water absorption rate,less affected by humidity and temperature for printing parts’dimension; self-lubricating and wear-resistant properties make it suitable for printing gears; high temperature resistance, continuous using temperature of parts can reach 120℃, short-term use temperature can reach 160℃; low shrinkage, not easy to warp and crack during printing, and the printing surface is matte and delicate.
Low moisture absorption
High strength
High toughness
High rigidity
High impact resistance
Chemical resistance
Heat resistance
Abrasion resistance
High dimensional stability
Matte surface effect
Excellent printability
Description
It is a material developed by eSUN and LUVOCOM based on PA12, added with 15% carbon fiber, greatly enhances the strength, rigidity and toughness of nylon, and can be used as a substitute for metal in many occasions; low water absorption rate,less affected by humidity and temperature for printing parts'dimension; self-lubricating and wear-resistant properties make it suitable for printing gears; high temperature resistance, continuous using temperature of parts can reach 120℃, short-term use temperature can reach 160℃; low shrinkage, not easy to warp and crack during printing, and the printing surface is matte and delicate.
| Filament Properties Table | |
|---|---|
| 3D PRINTING FILAMENT | ePA12-CF |
| Density(g/cm3) | 1.24 |
| Heat Distortion Temp(℃,0.45MPa) | 94.1 |
| Melt Flow Index(g/10min) | 8.91(270℃/2.16kg) |
| Tensile Strength(MPa) | 108.18 |
| Elongation at Break(%) | 9.02 |
| Flexural Strength(MPa) | 116.58 |
| Flexural Modulus(MPa) | 3335 |
| IZOD Impact Strength(kJ/m2) | 11.33 |
| Durability | 10/10 |
| Printability | 8/10 |
| Recommended printing parameters | |
| Extruder Temperature(℃) | 270 – 300℃ Recommended temperature：280℃ |
| Bed temperature(℃) | 45 – 60°C |
| Fan Speed | 0% |
| Printing Speed | 40 – 100mm/s |
| Heated Bed | Optional |
| Recommended Build Surfaces | Masking paper, PVP solid glue, PEI |
Submit Your Review
Required fields are marked *
John Doe March 22, 2021 at 1:54 pm
pellentesque habitant morbi tristique senectus et. In dictum non consectetur a erat. Nunc ultrices eros in cursus turpis massa tincidunt ante in nibh mauris cursus mattis. Cras ornare arcu dui vivamus arcu felis bibendum ut tristique.